RTX PRO 6000 owner's 12V-2x6 cables nearly melted even at a 500W limit

Started by BradBytheway, Today at 10:55 PM

Previous topic - Next topic

BradBytheway and 2 Guests are viewing this topic.

Topic: RTX PRO 6000 owner's 12V-2x6 cables nearly melted even at a 500W limit   Views(Read 28 times)
Active members in this topic:
BradBytheway(1)

BradBytheway

The power connector problems on high end Nvidia cards have not gone away. Tom's Hardware reports that a Reddit user posted photos in r/PcBuild showing that both 12V-2x6 cables feeding two RTX PRO 6000 Blackwell cards had stiff, cracked sleeving and two melted pins each

The cards had been power limited to 500W, below their 600W maximum. Thankfully the GPUs themselves were not damaged

The owner refused a suggested 300W cap, saying it would cost up to 50 percent of performance. Tom's Hardware calculates about 6.94A per pin at 500W, which should be fine on 16AWG wire, and blames uneven current across the pins and power spikes

Mitigations mentioned include Corsair's ThermalProtect 12V-2x6 cable, the Thermal Grizzly WireView Pro II, Aqua Computer's AMPINEL, or a custom board that splits the load into two 8 pin cables. The diagnosis is based on photos and commenters' views rather than measurements

Seeing damage even below the rated maximum is worrying for anyone running expensive cards at full load. Monitoring tools that check current per pin could catch problems early. Checking cables regularly is a sensible habit for anyone with a high power GPU

Have you had problems with 12V-2x6 or 12VHPWR connectors? And should GPU makers go back to multiple 8 pin cables?