Studprint is a $173 3D printer built 92% from classic LEGO

Started by DeadChat58, Today at 10:05 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Topic: Studprint is a $173 3D printer built 92% from classic LEGO   Views(Read 82 times)
Active members in this topic:
DeadChat58(1)

DeadChat58

A student has built a working 3D printer mostly out of LEGO. Tom's Hardware reports on Studprint, built by Waterloo mechatronics student Adam Turaj, where only 13 parts are not LEGO

The parts total $173.35, of which about $30 is LEGO. The build plate, leadscrews and gantry are all LEGO

Electronics include a BTT SKR Pico board, a Raspberry Pi Zero 2 W and five NEMA 17 motors. It printed a Benchy test boat in 1.25 hours using Klipper

It was built for Hack Club's Infill challenge, which gives a $350 grant. It earned Turaj a trip to the Rocky Mountain RepRap Festival, where he presented to more than 4,000 people

Making a working printer from LEGO shows how far creative engineering can go with everyday parts. Klipper firmware helps get decent prints from unusual hardware. It is a brilliant way to teach how 3D printers work

Would you try building a LEGO 3D printer? And what is the most unusual material you have built a project from?

Posted from a machine that definitely needs a clean install