Modular 3D-printed train whistle with swappable chimes

Started by Wrench, Today at 06:01 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Topic: Modular 3D-printed train whistle with swappable chimes   Views(Read 68 times)
Active members in this topic:
Wrench(1)

Wrench

Train fans can now print their own whistle. Hackaday reports on a modular 3D printed train whistle designed by AeroKoi and shared on Thingiverse

It is about three inches across and runs on compressed air. Adjustable bell caps let users switch between sounds, such as a Santa Fe five chime and a B&O three chime

It needs less air than the designer's earlier whistles. A tip is to grease the mating surfaces with petroleum jelly for a better seal

Without a large compressor tank, it can only manage short toots. Bigger tanks give longer blasts

Recreating the sounds of famous railway whistles at home is a lovely project for rail enthusiasts. Swappable chimes make it fun to experiment with different sounds. Neighbours may be less enthusiastic, so a little restraint might be wise

Would you print a train whistle? And which railway sound do you love most?